kernel/git - git - PowerEL Git System

Tree: 3b069b1beb

Author	SHA1	Message	Date
Stephan Beyer	d492b31caf	t/: Use "test_must_fail git" instead of "! git" This patch changes every occurrence of "! git" -- with the meaning that a git call has to gracefully fail -- into "test_must_fail git". This is useful to - make sure the test does not fail because of a signal, e.g. SIGSEGV, and - advertise the use of "test_must_fail" for new tests. Signed-off-by: Stephan Beyer <s-beyer@gmx.net> Signed-off-by: Junio C Hamano <gitster@pobox.com>	17 years ago
Junio C Hamano	41ac414ea2	Sane use of test_expect_failure Originally, test_expect_failure was designed to be the opposite of test_expect_success, but this was a bad decision. Most tests run a series of commands that leads to the single command that needs to be tested, like this: test_expect_{success,failure} 'test title' ' setup1 && setup2 && setup3 && what is to be tested ' And expecting a failure exit from the whole sequence misses the point of writing tests. Your setup$N that are supposed to succeed may have failed without even reaching what you are trying to test. The only valid use of test_expect_failure is to check a trivial single command that is expected to fail, which is a minority in tests of Porcelain-ish commands. This large-ish patch rewrites all uses of test_expect_failure to use test_expect_success and rewrites the condition of what is tested, like this: test_expect_success 'test title' ' setup1 && setup2 && setup3 && ! this command should fail ' test_expect_failure is redefined to serve as a reminder that that test should succeed but due to a known breakage in git it currently does not pass. So if git-foo command should create a file 'bar' but you discovered a bug that it doesn't, you can write a test like this: test_expect_failure 'git-foo should create bar' ' rm -f bar && git foo && test -f bar ' This construct acts similar to test_expect_success, but instead of reporting "ok/FAIL" like test_expect_success does, the outcome is reported as "FIXED/still broken". Signed-off-by: Junio C Hamano <gitster@pobox.com>	17 years ago
Junio C Hamano	5be60078c9	Rewrite "git-frotz" to "git frotz" This uses the remove-dashes target to replace "git-frotz" to "git frotz". Signed-off-by: Junio C Hamano <gitster@pobox.com>	18 years ago
Junio C Hamano	65aadb92a1	apply: force matching at the beginning. When there is no leading context, the patch must match at the beginning of preimage; otherwise there is a "patch adds these lines while the other lines were added to the original file" conflict. This is the opposite of match_end fix earlier in this series. Unlike matching at the end case, we can additionally check the preimage line number recorded in the patch, so the change is not symmetrical with the earlier one. Signed-off-by: Junio C Hamano <junkio@cox.net>	19 years ago
Catalin Marinas	cc189c2ca2	Add a test-case for git-apply trying to add an ending line git-apply adding an ending line doesn't seem to fail if the ending line is already present in the patched file. Signed-off-by: Catalin Marinas <catalin.marinas@gmail.com> Signed-off-by: Junio C Hamano <junkio@cox.net>	19 years ago